Introduction; To Use - Beurer Nail Pro Premium Manual De Instrucciones

4 Introduction

This manicure and pedicure device comes with high quality attachments.
The attachments included are made with durable sapphire coating or
polishing felt. Combined with continuously variable speed control and
selectable rotation directions, professional quality foot and nail care is
possible. All attachments can be easily stored into the storage pouch. The
integrated LED creates ideal lighting during use.
To charge:
1. Connect the USB power cord to the AC Power Adapter and plug the
adapter into an electrical outlet. Connect the round end of the power
cord to the device. When doing so, the device must be shut off (power
switch in the middle position). If the red/green LED flashes, the device is
switched on and cannot be charged.
2. Charge the device for about three hours before use. Three blue LEDs
will blink, indicating that the battery is charging. When all three LEDs
illuminate steadily, the battery is fully charged.
3. If the blue LEDs flash quickly (1, 2, or 3 LEDs depending on the speed
setting) during operation, it means the battery is almost dead and must
be charged.
You can charge the device by plugging it into the mains, or alternatively by
connecting the micro-USB port to a standard USB port on a power bank,
computer or other powered device.
A full charge will last for about two hours of operation.

5 To Use

1. Select an attachment and push it gently onto the device spindle until
it clicks into place. To remove, pull the attachment and device apart.
2. Switch on the device by moving the sliding switch down (anti-clock-
wise rotation, LED lights up red) or by moving the sliding switch up
(clockwise rotation(LED lights up green). Press the plus (+) and minus
(-) Buttons to increase or decrease the speed. Start every application
at low speed and increase only as required. Blue LEDs light up on the
surface of the device depending on the selected speed.
3. All file and callus attachments are coated with a sapphire grain to
ensure long life. Do not exert heavy pressure and always guide the
attachments carefully in circular movements slowly over the parts to
be treated.
7