Coffee Brewing - Saeco Vienna plus RI9737/20 Instrucciones De Uso

12
The manufacturer confi gures each appliance on an
intermediate grind setting: if the grind is too fi ne, rotate
the knob to a higher setting; if the grind is too coarse,
turn the knob to a lower setting.
The variation in grind will only be seen when three/
four coffees have been brewed.
Note: If the value has been changed
excessively - by turning the knob to very
low settings - the "no coffee" alarm might be
activated. Press the coffee brew button again to
reactivate the machine and to complete the coffee
grinding cycle.
Use coffee bean blends for espresso machines. Try
not to use very high or very low grind settings (e.g.
1 - 16). Use different coffee blends for different set-
tings. Keep coffee in a fresh place in a sealed, airtight
container.
The grind must only be regulated if coffee is not
brewed properly:
Too fast brewing = too coarse grind > Rotate the knob
to a lower setting;
Drip and/or absent brewing = too fi ne grind > Rotate
the knob to a higher setting.
6 COFFEE DOSE ADJUST-
MENT KNOB
(Fig. 24) - The desired coffee quantity (dose) to be
ground may be set in the machine.
The dose is set by the manufacturer to a medium value
that meets all tastes. Reference (A) in correspondence
with reference (B). By turning the knob (4) inside the
coffee bean hopper counterclockwise the quantity of
ground coffee is increased; by turning the knob clock-
wise the quantity of ground coffee is decreased.
The dose adjustment must be performed before press-
ing the coffee button.
This system allows an optimal brewing with any kind of
coffee on the market.
COFFEE BREWING - HOT WATER DISPENSING
7

COFFEE BREWING

Note: If the machine does not brew coffee,
make sure that the water tank contains
enough water by verifying the water level on the
left side of the machine.
Before brewing coffee, make sure that
the green temperature ready light (19) is
permanently on and that the water tank and the
coffee hopper are full.
• (Fig. 27 - 28) - Place 1 or 2 cups beneath the
dispensing spout (11). You may adjust the height
of the dispensing spout to your cups.
• Adjust the desired quantity of coffee to be brewed
by means of the knob (17): by turning the knob
clockwise the quantity of coffee to be brewed is
increased; by turning the knob counterclockwise
the quantity of coffee to be brewed is decreased.
• Press the button (18) to brew coffee. The brewing
cycle starts: press the button (18) once to brew 1
coffee. Press it twice to brew 2 coffees.
In this operation mode, the machine grinds
and measures automatically the right quan-
tity of coffee. Two coffees require two grinding and
brewing cycles that are automatically managed
by the machine.
• After the prebrewing cycle, coffee begins to come out
of the dispensing spout (11).
• On reaching the dose programmed with the knob
(17), the machine will automatically stop brewing. It is
nevertheless possible to interrupt coffee brewing by
pressing the button (18).