Cleaning And Care; Replacing The Light Bulbs - Bosch DHU665EL Instrucciones De Uso Y De Montaje

Cleaning and care

Disconnect the extractor hood from the elec-
tricity supply by pulling out the mains plug or
switching it off at the fuse box.
• At the same time as you clean the
grease filters, clean off any grease from
all accessible parts of the housing. This
significantly reduces the fire hazard and
ensures that the extractor hood performs
as effectively as possible.
• Use a hot detergent solution or a mild
window cleaner to clean the canopy of the
extractor hood.
• Do not scrape off any dirt that has dried
on but loosen it up with a damp cloth.
• Do not use abrasive cleaning agents or
sponges that could cause scratches.
• Note: Do not use alcohol (spirit) on plastic
parts, otherwise the surface may become
matt in appearance.
Caution: Ensure that the kitchen is ade-
quately ventilated. Avoid naked flames!
Clean the sliding switch with a soft,
damp cloth (mild detergent solution) only.
Do not use stainless steel polish on the
sliding switch.
Stainless steel surfaces:
• Use a mild non-abrasive stainless steel
cleaner.
• Clean the surface in the same direction as
it has been ground and polished.
Do not use any of the following to clean
stainless steel surfaces: abrasive sponges,
cleaning agents containing sand, soda, acid
or chloride!
Aluminium and plastic surfaces:
• Use a soft, non-linting window cloth or
micro-fibre cloth.
• Do not use dry cloths.
• Use a mild window cleaning agent.
• Do not use aggressive, acidic or caustic
cleaners.
• Do not use abrasive agents.
Installation Instructions

Replacing the light bulbs

The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting, a
duration up to 10 times as long as the tradi-
tional lamps and allow to save 90% electrical
energy.
For replacement, contact the technical
service.
Malfunctions
If you have any questions or if a fault occurs,
please call Customer Service. (See list of
Customer Service representatives).
When you call, please quote the following:
E-No.
Enter the relevant numbers into the box
above.
The E-Nr. (product no.) and FD (production
date) are shown on the name plate which
can be seen inside the extractor hood after
the filter frame has been detached.
FD
20