Cleaning And Maintenance - HQ-Power VDL8LS Manual Del Usuario

4. Mounting
Refer to the illustrations on pages 2 of this manual.
1 Truss
 [A] Locate the short bar (±19cm/7.3"; without pre-drilled holes) and two T-joints (without
safety pin) and attach them together as indicated.
 [B] Insert a short bar (±19cm/7.3"; with pre-drilled holes). (2x)
 [C] Align the holes and secure the connection with a bolt and wing nut. Place a washer on either
side of the bar.(2x)
 [D] Slide the assembly [A] over the truss.
 [E] Connect the two trusses as indicated.
 [F] Secure the connection with a bolt and wing nut. Place a washer on either side of the bar. (2x)
 [G] Secure the vertical bar in the T-joints with the butterfly nuts. (4x)
Note: the system can also be used with only a single truss between the two side bars. In this case,
skip step 1.
2 Side bar
 Locate an 80cm/31.5" top bar and slide into the 165cm/64" bottom bar, align the holes and secure
the connection with a bolt and wing nut. Place a washer on either side of the bar.
 Secure the butterfly nut for additional strength.
 Slide two T-joints (with safety pin) over the top bar. Do not secure them yet.
 Repeat above procedure to assemble the second side bar.
3 Tripod
 Open a tripod and secure it with the butterfly nut.
 Slide the bottom part (with pre-drilled holes) of a side bar (see [2]) in the tripod.
 Determine the desired height. Insert a safety pin through the applicable pre-drilled hole. The
safety pin will rest on the tripod (see illustration).
 Secure the butterfly nut of the tripod.
 Repeat the above procedure for the other side.
4 Mount truss
This step should be performed by two adult persons.
 Insert the truss (see [1]) simultaneously into the two T-joints of the side bars.
 Insert the safety pin through the T-joints and secure the butterfly nuts of the trusses.
 Determine the desired height, make sure the truss is level and secure the butterfly nuts on the
side bars.
5
T-bar
 Place a T-bar on top of each side bar. Rotate it in the desired angle and secure it with the butterfly
nut.
 Use the included bolts to attach devices (not incl.) to the T-bars.
5.

Cleaning and Maintenance


All screws should be tightened and free of corrosion.
 The device should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting
supports, do not change the location of the connections ...
 Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
V. 03 – 11/04/2018
VDL8LS
6 ©Velleman nv