Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
E N G L I S H
• Rubber Boot
• Auto Polarity
• Battery Replacement Indicator
3. EXPLANATION OF
CONTROLS AND INDICATORS
1.
Replace battery
2.
Maximum
reading
recording
3.
Max/min recording enabled
4.
Minimum
reading
recording
5.
Stand by enabled
6.
Continuity beeper enabled
7.
Diode test
8.
Display hold
9.
Measurement units
10. Analog display scale
11. Off scale arrow
12. Analog pointer (41 positiones)
13. Analog (+ or - shown) display polarity
14. Manual range
15. Toggle between volts DC and AC
16. Ranging operations
17. Volts DC/AC
18. Ohms
19. 6 Position rotary switch
20. Input jack
21. Common (return) jack
12
22. Capacitance
23. Frequency
24. Logic probe
25. Continuity/diode test
in
max/min
in
max/min
Holster and Stand.
The Meter comes with a snap-on holster
that absorbs shocks and protects the
Meter from rough handling. The holster is
equipped with a stand rest.
In Standby mode, the display just except
blinking STBY (STAND BY) goes to
preserve battery life. And in this mode
only microprocessor and a few power
components are active to reduce battery
consumption.
The Meter beeps and enters Standby if
4. STAND BY MODE
Publicidad
Capítulos
Tabla de contenido
