Flex ALR 411 M Instrucciones De Funcionamiento página 16

n Press the arrow button s (4) on the
power tool or the remote control to
adjust the position of the beam in an
anti-clockwise direction.
To return to "rotating laser beam" standard
operating mode:
n Keep pressing the mode button (5) until
the laser beam rotates.
Hairline function
In addition to the above operating modes,
a beam can be displayed at right angles
to the rotation level (laser cross).
n Switching on the power tool:
Press the On/Off button (2) on the
machine once.
n Switch on the hairline function:
Press the On/Off button (2) on the
machine again.
Note
If the machine is already in scan mode, it will
switch to the rotating laser beam when the
hairline function is switched on.
Horizontal application
n Place the power tool on a surface which
is as level as possible.
n Set the adjusting wheel (10) to "0".
n Level the machine.
To do this, rotate the foot screws (9, 11)
until the bubbles in the associated
horizontal spirit levels (8, 12) are exactly
in the middle between the hairlines.
16
n Switch on the power tool.
The LEDs (1, 3) light up.
On completion of work:
n Switch off the appliance.
Inclining the rotation level
When the machine is used for a horizontal
application, the rotation level of the laser
beam can be inclined by up to 4 %.
n Using the adjusting wheel (10), set the
required inclination within the range of
0 to 4 %.
n Level the machine as described
previously.
Rotational laser