Wiring Diagram - Velleman KSR2 Manual Del Usuario

Rana robot

Idiomas disponibles

Wiring Diagram

Operation

Put the switch in the "ON"-position. Place the device on the floor and verify whether it moves smoothly. Clap

your hands repeatedly to make the KSR2 execute the following steps: stop  move forward to the left  stop

 move forward to the right  stop  move forward in a straight line. Adjust "VR" with a screwdriver to

change the microphone's sensitivity. Turn the screwdriver to the right for increased sensitivity and vice versa.

Troubleshooting

1. Make sure all components on the PCB are in the right position. Pay particular attention to the polarity of the

microphone, the transistors, capacitors and the IC's.

2. Check the wiring.

3. The noise from the gearbox may prevent the microphone from receiving the signal. Grease face gear

36T/14T (white) and the metal shaft (n°3) to reduce the noise.

4. Do not grease metal shaft (n°4) and gears 36T/0T (white) and 36T/14T (red).

Use this device with original accessories only. Velleman nv cannot be held responsible in the event

of damage or injury resulting from (incorrect) use of this device. For more info concerning this

product and the latest version of this manual, please visit our website www.velleman.eu. The

information in this manual is subject to change without prior notice.

The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this

manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the

prior written consent of the copyright holder.

V. 02 – 31/01/2018

KSR2

Fig. 11

©Velleman nv

Tabla de Contenido