Configurations; Configuring Various Functions; Changing The Brightness Of The Indicators (Dimmer); Configuring The Hdmi Control Function - Yamaha ATS-1080 Manual De Instrucciones

CONFIGURATIONS

Configuring various functions

Changing the brightness of the indicators
(DIMMER)
Change the brightness of the indicators on the unit.
Each time DIMMER is pressed, the brightness of the indicators
changes as follows.
Dim (default setting) → Off → Bright → Dim → ...
Indicators glow brightly just after operation and change to the
specified brightness after a few seconds.

Configuring the HDMI control function

Enable or disable the unit's HDMI control function (link function).
This function coordinates TV and unit operation so that the unit can
be operated using the TV's remote control.
This function is enabled by default.
1
Turn off the unit.
2
Press and hold HDMI at least three seconds.
The HDMI control function is enabled or disabled, and
the unit turns on. The indicator shows HDMI control
function status for several seconds immediately after the
unit is turned on.
NOTE
▪ Enable the HDMI control function when connecting a TV that supports Audio
Return Channel (ARC), or when using HDMI signal pass-through. For details, see
the following:
– "Connecting a TV that supports Audio Return Channel (ARC)" (p.21)
– "Using a TV's remote control to operate the unit (HDMI control)" (p.32)
▪ If the unit cannot be operated with the TV's remote control, confirm that the HDMI
control function of this unit is enabled and the HDMI control function is enabled on
the TV. For details, see the following:
– "The unit cannot be operated using the TV's remote control" (p.41)
▪ The unit's power consumption will be reduced if the HDMI control function is
disabled.
35
En
Glows (enabled; default)
Off (disabled)