To Use Embedded Connectivity; To Prepare The Product For Inverted Drilling - Husqvarna DM400 Manual De Usuario

6. Make sure that the product is installed correctly. The
drill bit and the drill stand must be attached correctly.
7. When you do inverted drilling, make sure that you
comply to the applicable instructions. Refer to
prepare the product for inverted drilling on page 10 .
8. Make sure that the water system is not damaged
and that it is connected to the product.
9. Do the daily maintenance. Refer to
schedule on page 14 .
10. Make sure that the PRCD is started. Refer to
on page 7 and To examine the PRCD on page 8 .

To use embedded connectivity

Note: This part is applicable only for products supplied
with embedded connectivity.
Note: Radio transmission by the Bluetooth
be enabled on the first time of connection to a power
outlet, and stay on after that.
1. Download the Husqvarna Fleet Services iOS or
Android app Husqvarna Fleet Services.
2. Go to Husqvarna Fleet Services website https://
fleetservices.husqvarna.com for more information.
To prepare the product for inverted
drilling
WARNING: Always use a slurry ring with a
sealing disc and a rubber washer during
inverted drilling. Water that enters the
10
1. Clean the top of the slurry ring. All grease and dirt
2. Attach 2-sided adhesive tape or use spray glue
3. Look for the dimension of the core drill on the top of
To
Maintenance
PRCD
4. Cut a hole in the sealing disc in the nearest smaller
®
function will
product increases the risk of electrical
shock.
must be removed.
around the top opening of the slurry ring (A). Put the
sealing disc on the top opening as a cover (B).
Attach it tightly.
the drill.
dimension as the core drill.
A
B
1188 - 006 - 03.02.2020