Controls; Heat Sensor - GE UVC9300 Manual Del Propietario E Instalación

Controls

6 2
1. Rangehood Control Panel:
is located on the front of the canopy. The position
and function of each control button are noted below.
2. Fan On/Off Button:
The fan can be operated by pressing any of the fan
setting buttons. Hold for 3 seconds to activate Delay
Off feature, which automatically turns the fan off
after 15 minutes.
3. Fan Setting Button:
fan. Press the Low button for LOW speed, Med for
MEDIUM speed, and High for HIGH speed. Hold
down the High button for 3 seconds to activate the
BOOST speed that will run for 10 minutes.
On Remote, press Up to increase fan speed, press
Down to decrease fan speed, including Boost.
4. Light Button:
On/Dim/Off switch for the LED
lights. Press the Light button to turn the lights on,
again to set the lights to dim setting, and again to
turn the lights off.

Heat Sensor

Your hood is equipped with a HEAT SENSOR
thermostat. This thermostat is a device that will turn on
or speed up the blower if it senses excessive heat above
the cooking surface.
blower up to Med speed.
When the temperature level drops to normal, the blower
will return to its original setting.
49-80813-2
1 3
The control panel
On/Off switch for the fan.
Speed control for the
7
8
5
4 5
5. Chef Connect:
This is a Bluetooth
for use with other compatible Chef Connect enabled
products on a cooktop or range. When the device is
paired, the light and fan will turn ON at the Default
Sync Settings upon receiving a command from the
range or cooktop. It will remain ON at that setting until
the user changes it. To pair devices, hold down the
Chef Connect button for 3 seconds. To turn it back
off, hold the button down for another 3 seconds, see
the Chef Connect section for details.
6. IR Sensor:
Remote control reciever when used
with Remote Control Kit (UXRC1).
7. Wi-Fi:
Hold down the Light and Chef Connect
buttons for 3 seconds to activate the Wi-Fi. The
Wi-Fi light turns on when connected, see the Wi-Fi
Connect section for details. On Remote, press Wi-Fi
to toggle Wi-Fi function.
8. Delay Off (Remote only):
Delay Off to toggle Delay Off function.
3
4
7
2
Remote Control
pairing feature
®
Press and hold
5