AIR FILTER
AIR FILTER
CLEANING AND REPLACING THE AIR FILTER
The good performance and durability of engine parts, connecting rod,
piston, piston rings, crankshaft bearings, and the cylinder, depends on
the condition of the oil and the air filter.
To access the filter box you will need to remove the driver seat.
(See section REMOVE PILOT SEAT), then:
(See section REMOVE PILOT SEAT)
1 - Remove the 2 screws (A).
2 - Remove the cap (B) by pulling back.
3 - Remove the filter (C).
The air filter should be cleaned in the periods shown in the
maintenance table.
ATTENTION
ATTENTION
If you drive a moped in dusty areas you should increase cleaning
frequency. This will prolong the life of the moped and its engine
parts.
76
RS3 50
B
C
A
MAINTENANCE