Switching The Headset On; Establishing Bluetooth Connections - Sennheiser MM 100 Instrucciones De Uso

Putting the MM 100 into operation
¿
2 s
º
Searching mode
Idle mode
1s
Standby mode
3s
Audio streaming mode
4s
Active call mode
1s
Pairing mode
8

Switching the headset on

To switch the headset on:
Press and hold the Play/Pause button
An ascending confirmation beep is heard in the headset and the LED
Flashing in blue indicates that the battery charge status is OK; flashing in red indicates a low
battery (see page 6).
¿
The LED flashes several times every second:
The headset is paired to one or several Bluetooth devices and tries to connect to one of these devices.
¿
The LED flashes slowly (once every second):
The headset is paired to one or several Bluetooth devices. However, there is no current connection because the
Bluetooth device is switched off or out of range.
¿
The LED flashes once every 3 seconds:
The headset is paired to one or several Bluetooth devices. However, there is neither an audio transmission nor
an active call.
¿
The LED is glowing slowly every 4 seconds:
The headset is paired to one or several Bluetooth devices, a sound file is received via A2DP and played back or
paused.
¿
The LED flashes once every second:
The headset is paired to one or several Bluetooth devices and there is currently an active call.
If you switch on the headset and keep the Play/Pause button
pairing mode (see "Pairing the headset" on page 9).
¿
The LED flashes alternatingly in red and blue for up to 60 seconds:
The headset is not yet paired to any Bluetooth device. Pair it as described under "Pairing the headset" on page 9.

Establishing Bluetooth connections

If the MM 100 is not yet paired to any device, see "Pairing the headset" on page 9.
CAUTION! Danger of malfunction!
The transmitted radio waves can impair the operation of sensitive and unprotected devices.
Only use the headset in aircraft where wireless Bluetooth transmission is permitted.
After switch-on, the headset tries to connect to the Bluetooth device to which it was last
connected. If this device cannot be detected, the headset will go into idle mode.
º
for 2 seconds.
¿
º
pressed for 5 seconds, the headset will go into
indicates the current operating mode.