Leckey Mygo+ Manual De Usuario página 11

SECTION 7.3: ATTACHING THE SEATING
SYSTEM TO THE HI-LOW CHASSIS
Adjust the height of the chassis to its
maximum to reduce risk of back strain
while attaching the seat unit. Refer to
Section 11 on how to adjust the height
of the chassis you have purchased.
First release the safety locking pin at the
front of the seat A
pin out and rotate through 90 degrees.
Carefully lift the seat and place it into the
chassis. At the rear of the underside of
the seat you will see a receiving channel.
Place this securely over the tube towards
the back of the chassis.
Pull the handle at the front of the seat
unit up and then pivot the seat forward
and down. Once the front of the seat is
lowered fully, release the handle and
push it forward to ensure it has fully
engaged on the front tube
safety locking pin so it engages in front
of the handle. If it hits the handle then
the seat is not inserted properly. Remove
and repeat process outlined above.
Always check the handle
and locking pin are fully
engaged before you place
the child in the seating
system. If the handle is not
engaged properly the seat
unit can come loose and
could cause serious injury
to the child or carer.
. To do this pull the
B
C
. Rotate the
Leckey Mygo+ User Manual p11
A
C
C
A
B