Presentation - BraunAbility Turny Low Vehicle Instrucciones De Uso

26
Turny Low Vehicle
Operation

Presentation

Turny Low Vehicle has two basic functions: swivel the seat in/out and forwards/back-
wards movement for comfort. Note that it is not possible to swivel the seat when the
door is closed, nor is it possible to adjust comfort forwards/backwards once swivelling
out has begun.
The path that Turny Low Vehicle follows is preprogrammed by your installation techni-
cian In the case of faults or deviations from the preprogrammed path, the seat will stop
and cannot be manoeuvred normally. In this event, Turny Low Vehicle loses its position
and must be reset through an emergency operation. Fault message no. 23, Position lost,
is shown on the hand held control. Should this occur, follow the "Emergency Operation
by Hand Control" instructions. Once this is completed, Turny Low Vehicle will function
as normal again. Contact your installation technician if emergency operation must be
performed often.
In the case of certain electrical faults, emergency operation with the hand held control
will not work. One example is when the hand held control does not react to key presses
and the display is extinguished despite the door being open. Another example is when
fault message no. 2 Cable break in spiral connector to hand held control is displayed.
Should this occur, follow the "Emergency Operation with Emergency Operation Kit "
instructions. Always contact your installation technician after a manual emergency oper-
ation to remedy the fault before using Turny Low Vehicle again.