Maxell RC-R104 Manual De Usuario página 4

4. Changing the frequency of remote control signal
The accessory remote control has the two choices on signal
frequency Mode 1:NORMAL and Mode 2:HIGH. If the remote
control does not function properly, attempt to change the
signal frequency.
In order to set the Mode, please keep pressing the
combination of two buttons listed below simultaneously for
about 3 seconds.
(1) Set to Mode 1:NORMAL... MENU and MY BUTTON - 4
buttons
(2) Set to Mode 2:HIGH... RESET and MY BUTTON - 1
buttons
5. Using as a wired remote control
and it connects with the remote control's wired control port
via a cable with 3.5 mm diameter stereo mini plugs, the
remote control works as a wired remote control.
NOTE • This function can be used only for the
a cable with 3.5 mm diameter stereo mini plugs.
6. Buttons
at the end of this manual.
NOTE
not support. Some buttons may work differently from the following on your
(1)
(2)
(3) Turns the volume up/down.
(4) Turns off/on the screen and audio.
REMOTE CONTROL port,
REMOTE CONTROL port.
2
(2)
NETWORK INTERACTIVE
INFO
REMOTE
CONTROL port
Wired
control
port
3.5 mm diameter
stereo mini cable
Fig-1
(1)