Publicidad
Idiomas disponibles
Idiomas disponibles
Light emitting diode display area :
READY : After turning on the machine, it will automatically preheat for around 5 minutes. When the "READY" green light turns
from flashing into steady on, the machine is ready to work
DMX : Flashing means that DMX signal is connected, otherwise there is no signal
FAULT : When any malfunction, the light turns on
HEAT: When the machine is heating, signal light turns on
Control button area :
MENU : Short press to switch interface, press for 3 seconds can switch to the advanced setup interface.
-
: Reduce value
+
: Increase value
ENTER
: Confirm and save values.
Radio frequency identification area:
The Composite Ti is supplied with an RFID card, that is used to identify the parameters and types of
granules. Please note that granules RFID card can increase the single machine specific working time.
The card is disposable, one card can only use one time.
Interface
Main Interface:
First line: Displayed DMX address is "1".
Second line: Displays the present inner core temperature and the temperature progress bar; displays remaining time is 7
minutes and 24 seconds.
Error information display table:
Error Information
Explanation
E0 System IC
System error.
E2 Temp. Sensor
Temperature sensor was damaged.
E3 P Temp. Over
Chassis temperature too high leads to shut down.
E4 Time Remain
Insufficient granules or remaining time, please swipe time card.
E5 K Temp. Over
Inner core temperature too high, leads to shut down
E6 Heat Fail
Heating failed.
Dumping alarm when machine is tilted at less than 45 degrees. Machine stops working when tilt alarm is
E7 Tip Over
triggered.
- 3 -
Publicidad
