1600A018W0AA 02-18 PC10.qxp_Layout 1 2/7/18 7:28 AM Page 21
IMPORTANT CHARGING NOTES
1. The charger was designed to charge the tool
only when the battery temperature is be-
tween 32˚F (0˚C) and 113˚F (45˚C). If the tool
is too hot or too cold, the charger will not
charge the tool. (This may happen if the tool
is hot from heavy use). When the tool tem-
perature returns to between 32˚F (0˚C) and
113˚F (45˚C), the charger will automatically
begin charging.
2. A substantial drop in operating time per
charge may mean that the tool is nearing the
end of its life.
3. Remember to unplug the power adapter
during storage period.
The manufacturer is not responsible for radio
interference caused by unauthorized modifica-
tions to this equipment. Such modifications
could void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interfer-
ence, and
2) This device must accept any interference re-
ceived, including interference that may
cause undesired operation.
Charging Tool
4. If tool does not charge properly:
a. Try plugging in some other electrical de-
vice into the outlet.
b. Check to see if outlet is connected to a
light switch which turns power "off" when
lights are turned off.
c. Check charging base and power supply
terminals for dirt. Disconnect form outlet
and clean with cotton swab and alcohol if
necessary.
d. If the tool still is not charging properly, lo-
cate the nearest Dremel Service Center
and have the tool inspected.
Note: Use of power supply not sold by Dremel
will void the warranty.
FCC Caution:
NOTE! This equipment has been tested and
found to comply with the limits for a Class B
digital devices, pursuant to Part 15 of the FCC
rules. These limits are designed to provide rea-
sonable protection against harmful interference
in a residential installation. This equipment gen-
erates uses and can radiate radio frequency
energy and, if not installed and used in accor-
dance with the instructions, may cause harmful
interference to radio communications. How-
ever, there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference to
21