Back Panel Description; Voltage Selector - Palmer PEINS Manual De Usuario

2) BACK PANEL DESCRIPTION

7 8 9 10 11
7) IEC MAINS INPUT
Connect the included IEC cord to this socket for mains power supply.
Caution: Do not operate the amp without a protective grounding connection.

8) VOLTAGE SELECTOR

With this switch you can adjust the unit to the mains voltage of your
country. Usually you will not have to operate this switch as the unit is
generally pre-configured depending on the country it is delivered to. Be
sure to disconnect the unit from the mains before operating this switch!
9) SIMULATED OUTPUT
This is a line output for direct recording and connection to a PA system.
It uses the Palmer PDI-09's filter module for natural-sounding speaker
simulation. Connect this output to your recording interface or PA con-
sole using a quality instrument cable (1/4" plug to interface / console
connector type). Should you need a true DI-Output (balanced XLR out,
Transformer isolated, Mic level signal), then you may connect a standard
passive DI Box to this output.
Featuring a built-in dummy load, the EINS does not require speaker con-
nection for DI use. Whether you want to lay down a smoking track in the
studio, rip into a searing solo on stage or rehearse a new song with your
band, just bring your EINS, dial in the dirt, and spank the plank!
10) HI-Z OUTPUT
This output transforms the EINS into a preamp or "effect pedal". Deliver-
ing all of the amp's power stage performance the hi-Z out takes single-
ended tone to another level.
For preamp use, connect this output to a dedicated power amp using a
quality instrument cable with 1/4" plugs. This setup provides pure Class
A bliss at.volume levels limited by the power amp's output only.
Alternatively, run the EINS from the hi-Z out into any instrument ampfli-
er ("host" amps may impart their own tone). Always connect loudspeakers
to the power and instrument amps using quality loudspeaker cable.
10