DeWalt DW714 Manual De Instrucciones página 51

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fig. D2
34
9
3. Assemble the miter lock knob
(Fig. D3).
Fig. D3
4. Press down the operating handle (
out the lock down pin (
 15 
5. Gently release the downward pressure and allow the
arm to rise to its full height.
Fig. E1
1
 5 
to the miter saw arm
5
, Fig. E1) and pull
 1 
, Fig. E2) as shown.
13
18
Fig. E2
Transporting the Saw (Fig. E1, E2)

WARNING: To reduce the risk of serious personal
injury, turn off the tool and disconnect it from
the power source before attempting to move it,
change accessories or make any adjustments.

WARNING: To reduce the risk of serious personal
injury, ALWAYS lock the miter lock handle, bevel lock
handle, lock down pin, and fence adjustment knob
before transporting saw.
In order to conveniently carry the miter saw from place to
place, a carrying handle
has been included on the top
 13 
of the saw arm, as shown in Figure E1. To transport the saw,
lower the arm and depress the lock down pin
Figure E2.
Familiarization
Examine Figure A to become familiar with the saw and its
various parts. The section on adjustments will refer to these
terms and you must know what and where the parts are.
NoTE: Use the lock down pin when carrying the saw from
one place to another. Always use the carrying handle
to transport the saw or the hand indentations shown in
Figure E1.
Bench Mounting (Fig. F)
Holes
are provided in all four feet to facilitate bench
 10 
mounting, as shown in Figure F. (Two different sized holes
are provided to accommodate different sizes of screws. Use
either hole, it is not necessary to use both.) Always mount
your saw firmly to prevent movement. To enhance the tool's
portability, it can be mounted to a piece of 1/2" (12.7 mm)
or thicker plywood which can then be clamped to your
work support or moved to other job sites and reclamped.
NoTE: If you elect to mount your saw to a piece of plywood,
make sure that the mounting screws don't protrude from
the bottom of the wood. The plywood must sit flush on the
work support. When clamping the saw to any work surface,
clamp only on the clamping bosses where the mounting
screw holes are located. Clamping at any other point will
surely interfere with the proper operation of the saw.
ENGlIsH
15
 15 
shown in
49

Publicidad

Tabla de contenido
loading

Tabla de contenido