Correcting Horizontal Mitre Angles; Correcting Vertical Mitre Angles - Festool KAPEX KS 120 Manual De Instrucciones

18
22B
c) Laser beam is not positioned on the cut
[Fig. 3C]
Adjust the axial displacement.
22C
Left laser beam
Right laser beam

Correcting horizontal mitre angles

If the pointer (23.2) no longer rests on the preset
mitre angle values, you can loosen the screw (23.1)
and readjust the pointer.
Adjusting screw (22.1)
Adjusting screw (22.6)
23.1
23.2
23.3
If the actual (sawn) mitre cut deviates from the pre-
set value, you can correct this value accordingly:
– Engage the saw unit in the 0° position.
– Loosen the three screws (23.3) that secure the
scale to the saw table.
– Slide the scale together with the saw unit until
the actual value is 0°. You can check this by
setting an angle between the stop ruler and the
saw blade.
– Tighten the three screws (23.3) again.
– Check the angle setting by making a test cut.

Correcting vertical mitre angles

If the actual value no longer corresponds with the
preset value, you can correct this value accord-
ingly:
24a.1
24a.1
– Engage the saw unit in the 0° position.
– Open both screws (24a.1) below the cable
holder.
– Swivel the saw unit until the actual value is 0°.
You can check this by setting an angle between
the saw table and the saw blade.
– Tighten the two screws (24a.1) again.
– Check the angle setting by making a test cut.
24b.1
24b.2