Troubleshooting - Stanley STSM1525 Manual De Instrucciones

PROBLEMA
Saw makes unsatisfactory cuts
Blade does not come up to speed
Machine vibrates excessively
Machine vibrates excessively
Material pinches blade
TROUBLE SHOOTING
CAUSA POSIBLE
Gum or pitch on blade
Incorrect blade for work being done
Extension cord is too light or too long.
Low house current.
Saw not mounted securely
Stand or bench on uneven floor
Damaged saw blade
Miter scale not adjusted correctly
Blade is not square to fence
The blade is not perpindicular to the
table.
Workpiece moving
Cutting bowed material.
ENGLISH • 29
SOLUCIÓN POSIBLE
Remove blade and clean with
turpentine and coarse steel wool or
household oven cleaner.
Change the blade
Replace with adequate size cord
Contact your electric company
Tighten all mounting hardware.
Reposition on flat level surface
Replace blade
Check and adjust.
Check and adjust.
Check and adjust the guide.
Clamp workpiece to fence or glue 120
grit sandpaper to fence with rubber
cement.
osition bowed material as shown in
Fig. K.