Electrical Requirements; Removing The Unit Door; Replacing The Unit Door - Gladiator GAFZ30FDGB Manual De Uso Y Cuidado

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
This unit comes from the factory with a right swing door. If desired, follow these steps to reverse to a left-swing door.
IMPORTANT:
Depending on the width of the opening, you may need to remove the handle or door to move the unit into the house.
■
All graphics referenced in the following instructions are included later in this section after the "Final Steps" section. The graphic
■
may be reversed if the door swing is reversed.
Before you begin, turn the control off, remove food, and adjust the door or utility bins from door.
■
1. Remove Hinge Parts And Door
B
A. Top Hinge Cover
B. 5/16" Hex-Head Hinge Screws
C. Top Hinge
Unplug the refrigerator or freezer or disconnect the power.
Keep the unit door closed until you are ready to lift it free from
the cabinet. Remove the parts for the top hinge. Lift the unit
door free from the lower hinge and cabinet and set aside.
Replace the bottom hinge parts from step 2 onto the unit. Then replace the rest of the hinge parts and the door from step 1.
6

Electrical Requirements

Removing the Unit Door (optional)
A
B
C
Replacing the Unit Door (optional)
Before you move your refrigerator or freezer into its final location,
it is important to make sure you have the proper electrical
connection.
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only, 15 or 20 amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator or freezer be provided. Use
an outlet that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, press and hold TEMP SETTING for
3 seconds to turn off cooling, and then disconnect the
refrigerator or freezer from the electrical source.
2. Remove Bottom Hinge Parts
B
A. Hinge Pin
B. 3/8" Hex-Head Hinge Screws
Remove the four hex-head hinge screws and bottom hinge
assembly.
NOTE: Provide additional support for the door while the
hinges are being moved. Do not depend on the door magnets
to hold the door in place while you are working.
A