Installing The Heavy Duty Casters And Silver Tread Foot Pedals - Gladiator GAFZ30FDGB Manual De Uso Y Cuidado

Installing the Heavy Duty Casters and Silver Tread Foot Pedals

NOTE: Before installing the foot pedal, adjust the door swing direction, if desired.
1. Preparation
Replace the foam corner post on the non-hinged side, and
then place the unit on its side on top of cardboard or other
protective material. Make sure the door hinge is facing upward.
IMPORTANT: It is important that the door hinge face upward
during the entire caster installation to make sure the door will
not swing open during installation.
NOTE: If foam corner posts have been discarded,
2" x 4" boards may be used.
3. Remove Rear Screws
Break off the corners of the foam corner posts to gain access
to the large caster bracket screws on the left and right rear of
the unit. Remove the two rear caster bracket screws with a
TORX T40 screwdriver.
® ®
8
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator/freezer.
Failure to do so can result in back or other injury.
2. Remove Skid Bolts
Using a 5/16" nut driver, remove the four skid bolts (two on
each side) from the lower front and rear of the unit. Remove
the skids.
4. Remove Upper And Lower
Hex-Head Bracket Screws
Remove the four 3/8" upper and lower hex-head bracket
screws with a TORX T25 screwdriver or 3/8" nut driver.
® ®