Cleaning After Use - Bissell READYCLEAN 47B2 SERIE Guia Del Usuario

Operations
Hard floor cleaning
1. Remove the collection tank (refer to steps
2a and 2b on page 6).
2. Attach the hard floor tool by hooking it into
the front of the removable nozzle and rotate
until it snaps firmly in place.
3. Replace the collection tank. be sure to attach
the two latches.
4. Fill the solution tank with hot (not boiling)
tap water (140°F/60°C MAX) to the WATeR fill
line. Fill the rest with bissell 2X Hard Floor
solutions™ to FORMUlA fill line.
5. Follow steps 1-8 under "Carpet Cleaning" on
page 6 to continue cleaning.

cleaning after use

1. Unplug the unit.
2. Remove and rinse collection tank thoroughly.
3. Remove tank vent & foam filter (located on
top of the collection tank) and rinse.
4. Clean nozzle window by lifting latch and
removing nozzle from machine. Rinse under
running water.
5. 40N7 and 40H5 series models, pop out
CrossAction brush by pushing the tabs away
from each other and pushing down. Once the
brush pops out, rinse and replace by snapping
the tabs back into place.
6. When finished replace nozzle and secure
with latch.
notE: for best results, it is recommended
that the nozzle is cleaned after each use.
7. Remove lint and hair from red gasket in
base of unit. (Do not remove gasket)
8. Replace the collection tank on the base of
the machine and secure with latches.
(select models only)
WaRnInG
To reduce the risk of fire and electric shock- when
cleaning a hard floor, the BISSELL hard floor tool
(203-5683) must be used and it must only be used
with BISSELL 2X Hard Floor Solutions cleaning fluid
intended for use with this appliance.
2.
3.
5.
6.
www.bissell.com
4.
4.
7.
800.237.7691
7