Set The Basic Settings - JVC KD-X470BHS Manual De Instrucciones

Getting Started
9
Press to exit.
To return to the previous setting item, press
3

Set the basic settings

1
Press and hold .
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press
[SYSTEM]
[KEY BEEP] (Not applicable when 3-way crossover is selected.) (Page 30)
[ON]: Activates the keypress tone. ; [OFF]: Deactivates.
[SOURCE SELECT]
[AM SRC]*1 [ON]: Enables AM in source selection. ; [OFF]: Disables.
(Page 7, 9)
[PANDORA SRC]*1 [ON]: Enables PANDORA/PANDORA BT in source selection. ;
[OFF]: Disables. (Page 13)
[SPOTIFY SRC]*1 [ON]: Enables SPOTIFY/SPOTIFY BT in source selection. ; [OFF]: Disables.
(Page 14)
[BT AUDIO SRC]*1 [ON]: Enables BT AUDIO in source selection. ; [OFF]: Disables.
(Page 26)
[BUILT-IN AUX]*1 [ON]: Enables AUX in source selection. ; [OFF]: Disables. (Page 12)
6
ENGLISH
[F/W UPDATE]
.
[UPDATE SYSTEM]/[UPDATE HD]
[FACTORY RESET]
[CLOCK]
.
[TIME SYNC]
Default: [XX]
[CLOCK DISPLAY]
[ENGLISH]
[ESPANOL]
[FRANCAIS]*2
[DEMO MODE]
*1 Not displayed when the corresponding source is selected.
*2 Only for KD-X470BHS/KD-X370BTS/KD-X37MBS.
[F/W UP xxxx]/ [YES]: Starts upgrading the firmware. ; [NO]: Cancels (upgrading is not
[F/W UP Vxx] activated).
For details on how to update the firmware, visit
<http://www.jvc.net/cs/car/>.
[YES]: Resets the settings to default (except the stored station). ;
[NO]: Cancels.
[ON]: The clock time is automatically set using the Clock Time (CT) data in
FM Radio Broadcast Data System signal. ; [OFF]: Cancels.
[ON]: The clock time is shown on the display even when the unit is turned
off. ; [OFF]: Cancels.
Select the display language for menu and music information if applicable.
By default, [ENGLISH] is selected.
[ON]: Activates the display demonstration automatically if no operation is
done for about 15 seconds. ; [OFF]: Deactivates.