Cleaning, Maintenance And Replaceable Parts - e2v argus 4 Manual Del Usuario

4.

CLEANING, MAINTENANCE AND REPLACEABLE PARTS

•
Cleaning
After use and prior to stowing, the camera should be cleaned. This is best
carried out using a cloth soaked with warm soapy water. Solvents should not
be used. If in doubt, contact your supplier.
•
Maintenance
No routine maintenance is required for the camera. If it is not in regular use, it
should be switched on for a period of ten minutes every month to check correct
operation.
•
Replaceable Parts
Due to the environment in which the camera is used, the user can replace
certain parts. If any damage beyond these parts occurs, return the camera to
e2v technologies or an authorised repair centre.
Any attempt at repair by unauthorised personnel may cause serious damage
and will invalidate
SERVICEABLE PARTS.
Handle (P7030HA)
To remove the handle, spin the large thumbwheel anti-clockwise until the handle
detaches from the camera body. Refitting is the reverse of the above, making
sure that the locating pip is positioned correctly.
Side Straps (P7030SS)
To replace the side straps, remove the front and rear bumpers. Unbuckle the
straps and pull through the retaining pins. Replacement is the reverse of
removal.
Front Bumper (P7030FB), Rear Bumper (P7030RB)
To replace the front and rear bumpers, unclip the bumper from the groove in the
case body and peel off. Replacement is the reverse of removal, making sure
that the bumper fits into the groove.
Other Spares and Accessories
Accessory
Neck Strap
Rechargeable Battery Pack
Battery Charger Unit
Battery Charging Shoe
Remote Control
USB Computer Lead
Bung
User Manual
CD-ROM
Camera Carry Case
Hard Carry Case
© e2v technologies (uk) limited
the warranty. THERE
104077
ARE NO
Part Number
P7030NS
P7030R
P7030BC
P7030CS
P7030RC
P7030PC
P7030BU
P7030UM
P7030CD
P7030SC
P7030HC
DAS709758AA (UK) version 7, page 17
OTHER USER