Scaffolding Holder And Belt Clip; Magazine Attachment - Festool DWC 18-2500 Manual De Instrucciones

Depth stop disassembly

Remove the depth stop from the gear box by
pulling it.

Scaffolding holder and belt clip

Use the belt clip [8-1] to temporarily attach the
screwdriver on the working clothing – it can be at-
tached by means of a screw [8-2] to the left or right
of the power tool, and it is suitable for right and left
handed people – see figure [8].
The screwdriver is equipped with a scaffolding
holder [9-1] which is used for occasional machine
suspension. It can be attached to the left or right of
the power tool, by means of a screw [9-2] – see fig-
ure [9].
9
8
8-1
8-2
9-2
9-1

Magazine attachment

The magazine attachment enables to work contin-
uously, without unnecessary delays.
Fitting the magazine attachment

At first remove the depth stop [7-1], bit holder
[5-2] and bit, as specified in chapter Tool holder,
attachments.

Set the switch [1-4] into MAN position.

Push the long bit [10-1] completely to the hex-
agonal spindle opening [10-2].

Then fit the magazine attachment on the gear
box. Push the attachment until it engages in the
groove of the gear box.

The magazine attachment can be mounted at
30° steps.
10
Removing the magazine attachment

Use power to carefully pull the magazine at-
tachment from the gear box.
Setting the screw length

Press button [11-1] to remove and insert the
depth stop [11-2] and set the required screw
length.
Read the set screw length on the depth stop sides
.
[11-3]
11
11-1
11-2
MAN
10-1 10-2
11-3
15