batteries may exhibit unpredictable behavior resulting
in fire, explosion or risk of injury.
d ) Do not expose a battery pack or appliance
to fire or excessive temperature. Exposure to
fire or temperature above 266 °F (130 °C) may
cause explosion.
e ) Have servicing performed by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the product
is maintained.
f ) Only for use with S010QU2300040 and SSC-
230040US chargers.
EMC requirements for all digital devices
This device complies with Part 15 of the FCC Rules and Industry
Canada License-exempt RSS standard(s). Operation is subject to the
following two conditions:
1 . This device may not cause harmful interference, and
2 . This device must accept any interference
received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one of the following meaures:
ʵ Reorient or relocate the receiving antenna.
ʵ Increase the separation between the equipment
and receiver.
ʵ Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
ʵ Consult the dealer or an experienced radio/TV
technician for help.
CAN ICES-3(B)/NMB-3(B)
SAVE THESE
INSTRUCTIONS
SYMBOLS
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ..............................
volts
A .................................. amperes
Hz ................................ hertz
W ................................. watts
min ............................. minutes
or AC ................ alternating current
or DC .......... direct current
n o ............................... no load speed
.............................. Class I Construction
(grounded)
............................... earthing terminal
............................. safety alert symbol
.............................. Class II Construction
(double insulated)
.../min or rpm.
revolutions or reciprocation
per minute
Wh .............................. Watt Hours
ASSEMBLY
WARNING:
repair the appliance.
Intended use
Your BLACK+DECKER lithium ion cordless 2 in 1 canister
stick vacuum cleaner has been designed for light dry
vacuum cleaning purposes. This appliance is intended for
household use only.
Assembly (Fig. A, B–D)
1. Align the main handle/wand
shown in Figure B.
2. Push the main handle/wand
shown in Figure B.
3. Fit the lift away canister
5
into place as shown in Figure C.
4. Fit the hose
4
to the chassis hose port
Figure. D.
5. To stand the unit upright, angle the chassis forward so
that it is standing straight up. The floor head
the chassis in place.
WARNING:
upright unit with the rear of the chassis facing a wall
so that any inadvertent fall of the unit would contact
a wall and not people or pets.
English
Do not attempt to modify or
to the chassis
as
2
23
2
into the chassis
23
as
to the chassis
23
so it locks
6
as shown in
7
will hold
When not in use position the
3