Description Of Alarms - Ravelli HIDRO LINE HR100 Manual De Uso Y Mantenimiento

N.B.: The switch on phase after ECO STOP is the same as that of air
comfort and therefore if set at delta °C, when the temperature of the boi-
ler water goes below the comfort delta set (e.g. 60°C), the stove activates
at circa 4°C.
N.B.2:Stove functioning in COMFORT CLIMATE mode can start the switch
on and switch off phase multiple times during the day; this may compro-
mise resistor duration to automatically switch on the stove.
!
USING THIS METHOD, IT IS NECESSARY TO ENSURE THAT AFTER
EACH AUTOMATIC SWITCH OFF THE GRATE IS ALWAYS VERY CLE-
AN TO GUARANTEE CORRECT AUTOMATIC SWITCH ON. THE CLIMATE
COMFORT MODE ALSO FUNCTIONS WITH AN EXTERNAL THERMOSTAT.
8.3 "STAND-BY" mode
8.4. SELF CONTROL SYSTEM mode
8.5. SERVICE hours
8.6. Automatic loading of the hauger
Fig.37
Smoke 120°C
Hauger Status 1
It is possible to carry out this operation only if the stove is in FINAL CLE-
ANING or OFF status.
!
BEFORE SWITCHING ON THE STOVE, ALWAYS ENSURE THE
GRATE IS COMPLETELY EMPTY.
8.7. Operating warnings
Switch off the stove in the event of a fault or poor functioning using the OK key.
Do not manually place pellets in the grate.
The accumulation of unburned pellets in the grate after repeated non-
switch ons must be removed before proceeding with a new switch on.
Never empty the content of the grate into the hopper.
Never put fuel other than wood pellets inside the tank.
Never switch on the stove with inflammable materials in the event of a
switch on fault system.
Under no circumstances should the power supply cable come in contact
with the smoke release tube
!
NON-COMPLIANCE WITH THE AFOREMENTIONED RULES
COULD CAUSE SERIOUS DAMAGE TO PEOPLE AND PRO-
PERTY.
8.8. Remote control
(S.C.S.
ACCESS THE STOVE STATUS
MENU (SEE PAR. 7.3.1)
PRESS KEY 2 TO ACTIVATE THE
HAUGER
-
SAVE LIGHT MANAGEMENT
P1 - P2 Temperature regulation:
P4 - P
ter boiler
OK:
STAND-BY OR MENU MANAGEMENT
OK multi-function:
P1 - P4 multi-function:
P1
P4
8.9. Synthetic scheme phases
PHASE DESCRIPTION
-
FINAL CLEANING
terminated
SWITCH ON
WAITING FOR FLAME
FLAME PRESENT
-
WORKING
Air/water MODULATION
reached.
-
ECO STOP
-
T ON / T OFF
nected
-
FAN WAITING START
starts automatically
FAN WAITING
RE-START
automatically re-starts
WAITING SWITCH ON
RE-START
HOT SMOKE
Water STAND-BY
-
hydraulic circuit.
OFF
Switching on or Waiting
Flame
PELLETS FINISHED
EXCESS LOAD
condition.
!
IF THE "HOT SMOKE" SIGNAL IS DISPLAYED, IT MEANS THE-
RE ARE COMBUSTION PROBLEMS. YOU MUST CONTACT
YOUR LOCAL TECHNICAL SUPPORT CENTRE FOR AN IN-
SPECTION.

9. DESCRIPTION OF ALARMS

Set H2O regulation:
Example of alarm and solution
method. THERMAL SAFETY ALARM
and press the button to reset the
thermostat.
-
-
Pag.29