Operating The Fan; Cleaning And Maintenance - Orbegozo SFA 7000 Manual De Instrucciones

SFA 7000
Note: Do not add dirty water or any additives (such as perfume, essential oil and mosquito repel,
etc.), instead add clean drinking water or purified water to ensure longer product life.

OPERATING THE FAN

1. Insert plug to the electrical outlet, make sure that the indicator light is on as shown below.
2. Press "ON/SPEED" button, to choose the wind speed - Low, Med, High that matches the light on
the control panel.
3. Press "WIND" button, to choose the wind type, meanwhile the corresponding light switches on.
"Normal": Wind blow based on Low/Med/High speed.
"Natural": Imitate the blow of natural wind based on strong and soft wind.
"Sleeping": The first half an hour after running as strong and soft natural wind, it becomes med
natural wind. The second half an hour it changes to soft natural wind until the end of preset time.
4. Press "SWING" button, to change the wind direction, meanwhile the corresponding light switches
on. Press this button again to stop oscillation.
5. 5. Press "HUMIDITY" button, the indicator light is on, the HUMIDITY will spread out from the front
HUMIDITY plate, "HUMIDITY" button can be used separately, or worked together with the fan, and
this could feel cool wind. If the HUMIDITY function is used separately, it can increase humidity in the
air.
6. Press "TIMER" button to set the fan running time between 1 - 9 hours and switches the fan off
after preset time.
7. Press "OFF" button, it switches off the fan and all fan functions return to original state. However,
independent operation buttons are available.
8. "Remote Control", it must be aimed the infrared port when using remote control. If the remote
control doesn't work well, please first check the inside battery, and change new batteries if needed.
Note: Change the batteries with new and same types. Otherwise your remote control may not
operate properly. Remove the batteries out of the remote control if you won't use the remote
control for a long time. Remaining batteries may damage your remote control.

CLEANING AND MAINTENANCE

1. Please cut off the power cord plug from the electrical outlet and make sure that your fan is not
operating before cleaning it.
2. Please clean the water tank every two or three weeks, and clean the flume every week.
3. Please take out the water tank when cleaning it, and pull plastic tube out of the atomizing cup
properly, then take out the atomizing cup and cleaning them.
4. Use a dry cloth to absorb water remaining when cleaning the atomizing cup, and dry it using a
piece of soft cloth. Or use mild detergent to clean the atomizing cup if it is dirty.
5. Please add a few drops of lubricant to the motor shaft after cleaning to extend motor life every
year.
6. Pack this appliance properly and store it in a cool dry place if you are not using it for a period of
time.
15