Technical Specifications - Midland Alan 48Plus Multi B Manual De Instrucciones

TECHNICAL SPECIFICATIONS

GENERAL
Channels ...................................................................... (see the frequency band chart)
Frequency Range* ....................................................................26.565 - 27.99125 MHz
Duty cycle (% on 1 hour) ......................................... TX 5% - RX 5% - Stand-by 90%
Frequency Control .......................................................................................................... PLL
Operating Temperature Range ................................................................... -10°/+55° C
DC input voltage ..................................................................................... 12.6V DC ±10%
Size ........................................................................................... 180 (L)x50 (H)x150 (P) mm
Weight ..................................................................................................................................1kg
RECEIVER
Receiving system ................................................. dual conversion superheterodyne
Intermediate frequency ........................................I° IF: 10.695 MHz • II° IF: 455 KHz
Sensitivity ..............................................................0.5µV for 20 dB SINAD in FM mode
..................................................................................0.5µV for 20 dB SINAD in AM mode
Audio output power @10% THD .........................................................2.0 W @ 8 Ohm
Audio distortion .............................................................................less than 8% @ 1 KHz
Image rejection .............................................................................................................65 dB
Adjacent channel rejection ......................................................................................65 dB
Signal/Noise ratio .........................................................................................................45 dB
Current drain at stand/by .......................................................................................250mA
TRANSMITTER
Output power ........................................................................................................... 4W max
Modulation .....................................................................................AM: from 85% to 95%
.............................................................................................................. FM:1,8 KHz ± 0,2 KHz
Frequency response ..................................................................................... 300 Hz/3 KHz
Output impedance .................................................................. RF 50 Ohm unbalanced
Signal/Noise Ratio ...............................................................................................40 dB MIN
Current drain ............................................................................................................ 1100mA
* (covering all approved EU frequency bands)
Specifications are subject to change without notice.
6
A readily accessible disconnect device shall be incorporated in the installation wiring.
The disconnect device shall disconnect both poles simultaneously.
Hereby, CTE International declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 99/05/EC.