Installing The Unit - JVC KD-MR1BTS Manual De Instrucciones

Receptor de medios digitales
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation

Installing the unit

Ñ Mounting (Using Mounting Plate)
To mount the unit, you will need to find a flat surface
with adequate clearance behind it that provides
enough clearance for the unit and all it's necessary
wiring.
1) Once you have determined a mounting location,
you will need to cut a circular hole 77 mm (3inch)
in diameter.
2) After the hole is cut slide the unit and wiring
through the hole.
3) Slide the mounting plate (accessory 2) over the
backside of the unit and secure with the supplied
screws (accessory 4).
4) Press on the trim plate (accessory 1) to the front
side of the unit.
5) Plug in all wiring harnesses and cables. Refer to the
wiring diagram for wire harness connection types.
4 M3.5 × 25 mm
Ñ Mounting (Using U Bracket)
To mount the unit, you will need to find a flat surface
with adequate clearance behind it that provides
enough clearance for the unit and all it's necessary
wiring.
1) Attach the screw with nut (accessory 6) to the
back of the unit.
2) Once you have determined a mounting location,
you will need to cut a circular hole 77 mm (3inch)
in diameter.
3) After the hole is cut slide the unit and wiring
through the hole.
4) Take the bracket (accessory 3) and slide over the
two studs on the back of the unit. Tighten down
with supplied nuts (accessory 5).
5) Press on the trim plate (accessory 1) to the front
side of the unit.
6) Plug in all wiring harnesses and cables. Refer to the
wiring diagram for wire harness connection types.
16
2
Panel
(Max. 8 mm)
1
3
5
5
6 M4 × 37 mm
Panel
(Max. 15 mm)
Ñ Removing the trim plate
1) Use the extraction key (accessory 8) to lever out
the four tabs (two on the left part, two on the right
part).
8
2) Pull the trim plate forward.
1

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido