1. Introduction
1. Introduction ....................................................................1
2. Installation ......................................................................3
3. Starting and stopping the device ...............................4
4. Using polishing mode .................................................5
5. Maintenance...................................................................6
6. Troubleshooting............................................................7
7. Technical specifications ..............................................8
The Air Max
is an air-polisher. It enables treatment to be
®
carried out in optimal aseptic conditions.
Air Max
is equipped with a ProphyPen handpiece.
®
General characteristics
•
Polishing function via the powder drum.
•
Irrigation via the water supply with flow regulation on the
handpiece connector.
•
Foot control, via a pedal.
•
Integrated heating system for the spray for optimal
patient comfort.
The Air Max is a prophylactic device for polishing after
scaling, or in periodontal and implant maintenance.
Parts included
•
One Air Max device
•
One mains cord
•
One single pedal foot control
•
ProphyPen handpiece with titanium nozzle
•
Powder Max introductory powder kit
•
Pack three plastic nozzles
General view
Refer to relevant figure on the fold-out part of the cover.
1.
Rear panel
4.
Powder drum
2.
Front panel - Display
5.
ProphyPen handpiece
3.
Sensitive control panel
Front panel – Display
6. On/off button (O/I)
Lights up when the on/off button (ref. 10) is in I position.
Sensitive control panel
7. Purge key
A short press purges the handpiece powder circuit for a
predetermined length of time of a few seconds.
Rear panel
8. Compressed air supply filter
Before use the compressed air first passes through a filter
(ref. 8) with a purge button (ref. 13). A rapid disconnection
system with an automatic valve enables it to be connected to
the mains.
9. Foot control connector
Connection for the foot control pedal.
10. On/off button (O/I)
11. Air pressure adjustment
Air pressure is preset in the factory. For any adjustment of
the pressure, contact an approved installer of dental
equipment.
12. Drinking water supply connector
Its rapid disconnection system with an automatic valve
enables it to be connected to the supply. A removable filter is
located on the water inlet pipe.
1