Connecting To A Computer - Sony VPL-BW7 Manual De Instrucciones

Connecting to a Computer

Rear of the projector
INPUT A
INPUT
HD D-sub15-pin cable (not supplied) or HDMI-DVI-D cable
(not supplied)
: Video signal flow
Tip
Set "Input-A Signal Sel." in the SET SETTING menu to "Auto" or "Computer." If the input signal
does not appear properly, set it to "Computer." (1 page 39)
Notes
• The projector accepts VGA, SVGA, XGA, SXGA, SXGA+, WXGA signals. However, we
recommend that you set the output mode of your computer to WXGA mode for the external
monitor.
• To connect a Macintosh computer equipped with a video output connector of a type having two
rows of pins, use a commercially available plug adaptor.
• If you set your computer, such as a notebook type, to output the signal to both computer's display
and the external monitor, the picture of the monitor may not appear properly. Set your computer
to output the signal only to the external monitor.
For details, refer to the computer's operating instructions supplied with your computer. For
settings of the computer, consult with the manufacturer of the computer.
• The HDMI connector of this projector is not compatible with DSD (Direct Stream Digital) Signal
or CEC (Consumer Electronics control) Signal.
• When connecting an HDMI cable to the projector, make sure the
HDMI input of the projector and the
position.
SERVICE
to monitor
output
v
mark on the connector of the cable is set at the same
Computer
to DVI-D
output
v
mark on the lower part of the
21
GB