Installation Menu - EisSound KBSOUND PREMIUM Manual De Uso

3. Installation
3.1 Wiring Diagram
Installation involves two elements: a Control Unit (powered to 15Vdc) and loudspeakers. See page 2
If the room is monophonic, connect any of the speakers and set the Control Unit to MONO. (See 3.2.1. Mono/Stereo Installation)
·
8 speakers can be connected to the
· W
Installation).
· To connect the FM antenna, connect a 76 cm wire to terminal A or connect a 75
If it is necessary to connect an amplifier or power stage to a Control Unit's output, the Control Unit must be set to AMPLIFIER. (See 3.2.2. Audio
·
Output Installation). Connect the amplifier to terminals 2, 4, 05 and 06 on the Control Unit.
All wire sections are AWG24 0.25 mm except supply wires (terminals 2 and 4), which are
·

3.2 Installation Menu

The following information is, in its totality, the installation data for the Control
Unit. To modify the data, access the installation menu of the Control Unit itself.
See 8. Quick Reference Guide
3.2.1 Mono/Stereo
Defines whether the Control Unit's audio output (terminals 04, 05, 06) is connected in
mono or stereo mode. In a Control Unit in stereo, outputs 05 and 06 respond to the left
and right channels. In a Control Unit in mono, both outputs are identical and can
therefore be used interchangeably.
Control Unit outputs. In this case, the
2
( )
Control Unit must be set to 8
W antenna input to terminals A (signal) and M (mass).
To change the output setting to mono
. (See 3.2.2. Audio Output
W
2
AWG18 (1mm ) .
Key Sequence
2''
1
PRG
2
abc
Store
PRG
7
ENG
Display Visual
stereo/mono
stereo
mono
CC-1140-02.1