Hardware Setup - Velleman CCTVPROM7 Manual Del Usuario

Front panel
1 channel selectors
2 quadruple screen selector
3 manual record button
4 menu button
5 PTZ control button
6 playback button
7 escape button
Rear panel
A USB-port
B output signals V
OUT
C input signals V 1~V
IN
D PS2 input
Camera
a lens
b IR LEDs
c light sensor
d sunshield
Remote control
MULTI Switch to quadruple view or full screen sequential view of each camera image for ±5s.
1 2 3 4 Select channel
PTZ enter PTZ control menu
CLEAR clear entry field
MENU enter OSD menu
REC enter recording menu
arrow keys to scroll through OSD
OK confirmation button
ESC escape
FN display PIP (Picture in Picture): a small image of CH1 is shown inside the full screen image of CH2
Note: other keys on the remote control have no function programmed for this DVR.

6. Hardware setup

Refer to the illustrations on page 2 of this manual.
The DVR comes with a HDD installed. To replace it, refer to §8)
•
Make sure the device is unplugged from the mains before making any connections and do not touch any
•
electronic circuitry to avoid electrostatic discharge.
Connecting the cameras
Choose a location for the camera, keeping following guidelines in mind:
•
do not install the camera in locations where extremely high or low temperatures or excessive vibrations
•
may occur.
avoid mounting the camera near high electro-magnetic fields.
•
do not aim the camera at the sun or other extremely bright objects or reflections (e.g. metal doors).
•
The included signal/power cables are 18m each.
•
Use the mounting bracket [f] to determine the location of the mounting holes. Drill the holes and secure the
•
bracket [f] using 3 screws.
Attach the camera to the mounting bracket [f] with the camera bolt (rear).
•
Point the camera towards the field of interest and tighten the position bolt [e].
•
Connect the power [h] and BNC [g] connector to the signal/power cable.
•
Connect the other end of the signal/power cable to the DVR. The channel number is indicated above the BNC
•
connector [C]. It determines the position of the image on the screen. Make sure to use the matching DC-
output [E] to facilitate any troubleshooting.
Connecting the mouse
Plug the PS2-mouse connector into the PS2 input [D].
•
Connecting a PTZ camera/serial line
Connect the PTZ data line to terminals 485T- and 485T+ of the PTZ connector [F]. Use a suitable small
•
screwdriver to tighten the wires.
14/07/2010
CCTVPROM7
-1/V -2 (BNC)
OUT
4 (BNC)
IN
playback control buttons
8 arrow buttons
9 confirmation button (OK)
10 power LED
11 system LED
12 recording LED
13 USB status LED
14 LCD power switch
E DC outputs DC1~DC4
F PTZ/RS-485 connector
G 12 VDC input
H ground connector
e position bolt
f mounting bracket
g Video output connector
h DC 12V input terminal
4
©Velleman nv