Publicidad
Idiomas disponibles
Idiomas disponibles
symptoms
occur such as numbness,
pain,
loss of strength, change in skin color or texture,
or loss of feeling in the fingers, hands, or joints,
discontinue
the use of this tool and seek
medical
attention.
An anti-vibration
system
does not guarantee
the avoidance of these
problems. Users who operate power tools on
a continual and regular basis must monitor
closely
their
physical
condition
and the
condition of this tool.
SPECIAL
NOTICE:
Your saw is equipped
with a temperature
limiting muffler and spark
arresting
screen
which
meets
the
requirements
of California
Codes 4442 and
4443.
All U.S. forest land and the states of
California,
Idaho,
Maine,
Minnesota,
New
Jersey, Oregon, and Washington
require by
law that many internal combustion
engines
to be equipped with a spark arresting screen.
If you operate a chain saw in a state or locale
where such regulations
exist, you are legally
responsible
for maintaining
the operating
condition of these parts.
Failure to do so is
a violation of the law. Refer to the SERVICE
section
for
maintenance
of
the
spark
arresting screen.
Failure to follow all Safety Rules and Precau-
tions can result in serious injury. If situations
occur which are not covered in this manual,
use care and good judgement.
If you need
assistance,
contact your authorized service
dealer or call 1-800-554-6723.
STANDARDS:
This saw is listed by Under-
writer's Laboratories, Inc., and the Canadian
Standards Association in accordance with:
ANSI
B175.1-2000
American
National
Standard
for Powered
Tools
- Gasoline
Powered Chain Saw - Safety Requirements
CSA Z62.1-1995
Chain Saws - Occupa-
tional Health and Safety
CSA Z62.3-1996
Chain Saw Kickback Oc-
cupational
Health and Safety
Protective
gloves (not provided)
should be
worn during assembly.
ATTACHING
THE BAR & CHAIN
(If not
already attached)
_ WARNING:
If received assembled,
repeat all steps to ensure
your saw is prop-
erly assembled and all fasteners are secure.
Always
wear
gloves
when
handling
the
chain.
The chain is sharp and can cut you
even when it is not movingt
1. Loosen and remove the chain brake nuts
and the chain brake from the saw.
2. Remove the plastic shipping
spacer (if
present).
Location of shipping
spacer
chainBak
Ch
Nuts
Bar Tool
3. Turn adjusting
screw on bar counter-
clockwise to move the tensioning
rack as
far as it will go toward the front of the bar.
°
AdiU;e" g
Tensioning
Rack
//_
'_
4. Slide the bar behiod clutch drum until bar
stops against clutch drum sprocket.
5.
Prepare
the chain by checking the proper
direction. Without following the illustration it
is easy to place the chain on the saw in the
wrong direction. Usethe illustration ofthe
chain to determine the proper direction.
of
DIIRECTION OF ROTATION
Cutters
Depl i Gauge
Drive Links
6
Publicidad
