Auto Mode - Cameo CLMHRGB60W Manual De Usuario

OPERATION:

AUTO MODE

Press the MODE button ("Addr" will appear in the display) and then use the
UP and DOWN buttons to select the Auto mode ("AUTO" will appear in the
display). Now press the ENTER button and use the UP button to select the
Master mode (MAST) or DOWN to select the Stand-alone mode (ALON) and
confirm with ENTER. The display will now read "AU-M" for Master mode or
"AU-A" for Stand-alone mode.
In Master mode, additional lights of the same type can be used as slave
units on the master unit. Select the DMX mode for the slave unit and set the
DMX start address to 001. Using a DMX cable, connect the slave unit(s) to
the master unit (master unit DMX OUT - slave-unit DMX IN). Now the slave
unit follows the master unit.
In stand-alone mode, the light operates independently of any other units
connected to it.
SHOW MODE
Press the MODE button ("Addr" will appear in the display) and then use the
UP and DOWN buttons to select the Show mode ("SHOW" will appear in the
display). Now press the ENTER button and use the UP button to select Show
1 (SH-1) or DOWN to select Show 2 (SH-2) and confirm with ENTER. Show 1
and Show 2 contain pre-programmed sequences of motion and colour and
gobo changes.
REVERSE PAN
This function makes it possible to reverse the PAN motion.
Press the MODE button and then use the UP and DOWN buttons to select
the Reverse Pan function ("r PAN" will appear in the display). Now press the
ENTER button and use the UP button to select Reverse On (ON) or DOWN to
select Reverse Off (OFF).
Confirm with ENTER.
9