Bosch He44C Manual De Uso Y Cuidado página 17

. return the top rack to the top rack roller guides.
To remove the bottom spray arm:
1. remove the empty bottom rack from the dishwasher tub.
2. Grasp and lift the bottom spray arm as shown in figure 27.
3. look for obstruction in the spray nozzles.
To reinstall the bottom spray arm:
1. return the bottom spray arm to its installed position and press it so that it snaps into
place.
2. return the bottom rack to its installed position.
Check/Clean the Filter System
located on the inside of your dishwasher under the lower rack and is easily accessible.
foreign objects and clean it when necessary.
CAUTION
object trap could contain sharp objects.
under the lower rack and is easily accessible.
foreign objects and clean it when necessary.
To Remove the Large Object Trap/Cylinder Filter Assembly:
1. remove the bottom rack.
2. Grasp the assembly as shown in figure 28 and turn it counter-
clockwise 1/4 turn.
3. lift out the assembly as shown in figure 29.
upside-down and gently tap it on a surface such as a countertop to dislodge and
remove the debris. flush the Cylinder filter clean by holding it under running water.
To Remove the Fine Filter:
1. return the fine filter to its installed position.
2. place the large object trap/Cylinder filter assembly into its installed position in the
3. turn the ring handle clockwise 1/4 turn until it is locked. the arrow
on the ring handle and the arrow on the fine filter should point to each other, as
shown by the circle in figure 31.
4. Gently pull the ring handle to ensure that the assembly is locked into place.
ATTENTION
To avoid possible diswasher damage, do not use harsh chemicals, abrasive cleaners,
washer's exterior door panel. Your dishwasher's exterior door panel can be damaged
by doing so.
Figure 8
To open - turn counterclockwise.
Figure 9
large object trap/Cylinder filter
Figure 0
Figure 1
-
To close - turn clockwise.
Fine
Filter
1