Bresser MicroSet 40-1024x Instrucciones De Uso página 17

**System requirements: Intel X86 processor with at least
2.0 GHz speed, 200 MB hard disc space, 512 MB RAM
memory, Windows XP or Vista (32-bit) and a free USB port
(not via a hub if possible).
Using the MicrOcular
Preparation
1. Slide a specimen under your microscope
and focus on it.
2. Remove the eyepiece and Barlow lens
from the eyepiece support and the dust
cap from your MikrOkular and install same
in the eyepiece supports instead of the
Barlow lens.
3. Start your PC if you haven't yet and connect
your MikrOkular to the USB port of your
computer.
Showing and
MikrOkular images on your
PC.
1. Start the Photomizer SE
Software.
2. Click „Open camera"
3. If you have more than
one device connected up
select the one you want
from the choice offered.
Click „SoC PC-Camera" or
„MikrOkular". Omit this step
if you only have a single
device connected up.
4. The camera image should now be visible
on your screen. Focus the microscope
image.
5. Click „Capture" to record an image. It will
then be shown on the right.
6. Click on it to select it and then click
„Transfer image".
7. This takes you to the Photomizer SE
software.
8. File - Save as
saving The Photomizer SE software
If you need help in the „Photomizer SE"
programme click „?" and then „Open help".
If you need further assistance please visit the
maker's home page at www.photomize
Make sure your microscope has a long
service life.
Clean the lens (objective and eyepiece) only
with the cloth supplied or some other soft lint-
free cloth (e.g.microfi bre). Do not press hard
as this might scratch the lens.
Ask your parents to help if your microscope
is really very dirty. The cleaning cloth should
be moistened with cleaning fl uid and the lens
wiped clean using little pressure.
Make sure your microscope is always protec-
ted against dust and dirt. After use leave it in
a warm room to dry off. Then install the dust
caps and keep it in the case provided.
GB
17