Assembling The Plastic Profiles On The Posts; Installation Of The Pool Wall - Trigano Jardin 880115 Instrucciones De Montaje

11. Assembling the plastic profiles on the posts

Before starting to assemble the posts themselves, assemble the plastic profiles on to the posts (note there are 2 types of posts:
for the round part and the straight part).

12. Installation of the pool wall

WARNING: An incorrectly installed metal sheet could cause the pool to collapse. Do not install the metal sheet in windy
weather.
NOTE: For some larger sized pool models, the wall is composed of two half-walls in order to facilitate handling (for some
models, the weight of the wall may exceed 100 kg). This does not change the way in which the wall is installed.
Use the ladder to enter and exit the pool during installation. Take the pool wall out of the
box and place it on top of the box or on a board for easy unravelling.
Ensure that the skimmer cut out is placed on the top part of the metal sheet, with
the opening positioned facing the prevailing wind, so that the wind blows any
impurities towards the skimmer.
We recommend installing the metal sheet wall so that the skimmer and discharge nozzle
cut outs are located on a rounded side of the pool and not on a straight side of the pool.
Begin by pushing the metal sheet into the groove of the profiles and continue until the wall
is completely unrolled.
Start in the middle of a connecting plate so that the bolts are hidden by a
vertical post. Join the extremities of the metal sheet using the bolts and washers.
The screw heads must be on the inside and the nuts on the outside. Ensure
that all the bolt holes are used. It is very important for all the bolts to be
adequately tightened to ensure a solid join. To protect the liner, stick a protection
band (duct tape) over the screws on the inside of the pool.
IMPORTANT: Increase the stability and rigidity of the metal sheet by
temporarily placing the top metal profiles and the vertical posts (round
part) as you go along. On the lower part, fix the posts to their connecting plate
using 2 screws; on the upper part, fix the posts to their connecting plate with 3
loosely tightened screws.
OSMOSE Oval
121510
M6 nut
101
88034X
Plastic profile
2377
Vertical post
Skimmer and discharge
nozzle pre-cuts
Inside
Sides
121610
M6 washer
Assembly Guide 880115-rev A
121000
M6 screw
Exterior