Timer - Teac R-5 Manual Del Usuario

ALARM 1/2
< The unit can be programmed to turn on
at a specified time. The unit will turn off 60
minutes after the specified turn on time.
< The unit can store 2 timer settings into
memory.
< Adjust the clock before setting the timer.
The procedures below are to set ALARM 1.
Follow the similar steps to set ALARM 2.
1
Press and hold the ALARM 1 button for
more than 2 seconds.
"Set alarm <Off>" appears on the display.
< If no button is pressed for 10 seconds, the
timer setting mode will be cancelled.
2
Turn the MULTI JOG knob to select
<ON>, and then press the ALARM 1
button.
16 16

Timer (1)

MULTI JOG
3
Turn the MULTI JOG knob to set the
start time, and then press the ALARM 1
button.
4
Turn the MULTI JOG knob to select a
source (FM, AM or Buzzer), and then
press the ALARM 1 button.
< You cannot select "AUX".
< If you select Buzzer, proceed to step
5
If you select FM or AM in step
into a station using the MULTI JOG
knob to select <FREQ> or <PRESET>,
and press the ALARM 1 button.
6
Turn the MULTI jog knob to select a
frequency or preset station, and press
ALARM 1 button.
7
Set the volume using the MULTI JOG
knob, then press the ALARM 1 button.
You could also leave the unit idle for 10
seconds instead of pressing the ALARM
button. In this case, volume is set to 15
automatically.
Setting the timer is now completed and the
timer is turned on.
The ALARM 1 indicator lights up.
8
Press the STANDBY/ON switch to turn
the unit off (standby).
Do not forget to turn the unit off
(standby), or the timer won't work.
.
7
4 , tune