NORAUTO 123 Instrucciones De Uso página 49

adjusted harness is essential to ensure maximum protection for your child. There should not
be more than two fingers width between the harness and the child.
Installing the car seat without the harness
Group 2-3, 15 to 36kg (approx. 3 to 12 years)
WARNING
This is a 'SEMI-UNIVERSAL' SAFETY RESTRAINT DEVICE FOR CHILDREN. It is compliant with
•
Regulation 44/04 and may only be used in vehicles specified in the adjoining list of approved
vehicles.
• It can only be fitted on vehicles with 3-point safety belts, whether fixed or inertia-reel, com-
pliant with UN/ECE N°16 or an equivalent standard.
If in doubt, please contact the car seat manufacturer or the retailer.
Ensure that the harness and the Top Tether strap of your car seat are removed before
beginning installation in your vehicle.
Removing the harness and the Top Tether strap
(17)
Remove the Top Tether strap and store it carefully for future use. Press on the red harness
(2) (3)
button to undo the harness if necessary. Repeat steps and on each upper section of the
harness. Take one section of the harness and feed it to the back (18), attach the metal anchor
of the harness to the back of the seat (19). The metal anchor must be positioned between
the shell and the car seat cover. Repeat the procedure on the second section of the harness.
Check that the harness connectors have also been passed behind the back rest. Remove the
crotch strap by twisting the metal keeper and by passing it through the slots in the base and
the cover (20).
Installing the car seat and placing the child in the vehicle
Your car seat is fitted with an adjustable headrest that has been designed to support your
child throughout growth by providing maximum lateral protection.
IMPORTANT: When using the car seat without the harness, it must only be installed with a
3-point safety belt (21). Never install the car seat within 2-point safety belt (22)!
Raise the adjustable headrest to its highest position. Extend the ISOFIX/EASYFIX connectors
from the car seat as far as possible by pulling simultaneously on the red handle on the base
and the red ISOFIX/EASYFIX system strap (7). Position the car seat on the rear seat of the vehi-
cle bringing the ISOFIX connectors in line with the seat's ISOFIX anchor points (23). Click the
ISOFIX connectors into the anchor points; the indicators on each connector should turn from
red to green (24). Ensure that the vehicle seat belt buckle remains accessible and that it has
not been placed under the car seat.
Release the safety catch of the ISOFIX/EASYFIX system by pulling the red handle attached to
the base and gently pushing the car seat (25). With the safety catch released, push the car
seat by exerting equal pressure on both sides until the rear of the car seat is pressed firmly
against the vehicle seat and then feed the diagonal strap of the belt through the headrest
49
User guide - EN