Trouble Shooting - Hayward AquaVac KingShark2 DC Manual Del Usuario

Where to set Sensor Bar
(Make adjustments in 1/4" increments)
Machine fails to come out of deep end:
Raise sensor bar to allow the machine to climb the incline to shallow end.
Machine turns in circles and twists cord:
1. Sensor bar too high, hitting hood, or is not level.
2. Thread on reversing arm RCx2203 (Fig. 1, Key 30) is worn or stripped, not
allowing reversing mechanism to disengage.
3. Drive wheel broken.
4. Drive belt broken.
5. Is the unit being run in the pool for too great a length of time? Four hours in
operation in the larger pools should be sufficient with not more than a few twists
in the cord, which should be straightened out after each vacuuming.
KeeP SenSOr Bar leVel at all timeS!
Machine does not pick up:
1. Filter may be clogged and not permitting the flow of water through the filter
cartridges, (clean filter cartridges).
2. Large object lodged in the intake or in the impeller housing (remove object).
Machine does not move:
1. Not connected to live outlet, (check electrical source).
2. Object lodged in impeller, (remove object).
3. A short in the motor or swivel, (check the ground fault interrupter for tripping).
4. Unit runs for short distance but stops, (check for overloaded circuit or possible
faulty motor). *Contact service center*
5. Motor runs but unit becomes motionless, (gear box worm is worn or the drive pin
is sheared). *Contact service center*
Machine tips over:
1. Improper sensor bar adjustment, (too high).
2. Cord too short for pool length. *Contact service center*
3. you may need optional float Part No. RCx7. Call local dealer/service center.
4. you may need optional sensor bar slide with weight Part No. RCx3208W (Fig. 6).
Call local dealer/service center.

trOUBle SHOOtinG

(DO NOT USE EXTENSION CORDS)
11