Hayward AquaVac KingShark2 DC Manual Del Usuario página 36

OPeratinG tHe KinGSHarK2 DC
2. Connect cleaner power cord to power supply.
NOTE: The power supply must be installed in a
fixed station to a minimum of 3.5 meters from the
pool edge
4. Switch the light on/off switch to "ON" position. The
cleaner will start clean the pool and shut down
in approximately 4 hours. Turn off the switch and
unplug power cord from the wall receptacle after
each use.
1. Submerge the cleaner in the pool.
3. Connect power cord from power supply only to
a protected 230 V outlet that is close and
protected from short-circuits. This outlet must have
a 30 mA differential protection device to protect
people from electric shock caused by a possible
break in the electrical insulation.
5. Remove the cleaner from the pool immediately
after each use. To reduce the weight of the cleaner
first remove the filter by using the supplied pole
hook.
12