Answering And Making Telephone Calls; Muting A Call; Automatic Volume Adjust; Visual Indicators - Jabra GN8210 Manual Del Usuario

4.1 Answering and making telephone calls

To answer or make a telephone call:
1. Put the headset on.
2. Make sure that the handset/headset switch (H) is set to headset, and that the
mute switch (F) is not activated. (The mute indicator light should not be fl ashing).
3. Lift the telephone's handset out of its cradle and answer the call/dial the
number.
4. To end the call, replace the handset on the telephone.
To answer or make a telephone call using a handset:
1. Make sure that the handset/headset switch (H) is set to handset.
2. Lift the telephone's handset out of its cradle and answer the call/dial the
number.
3. To end the call, replace the handset on the telephone.
Note: It is recommended that you always use the headset, otherwise you will not
benefi t from the GN 8210's features and protection.

4.2 Muting a call

To mute a call so that the other party is not able to hear you,
set the mute switch (F) to the mute position. The mute indi-
cator (F) will fl ash and low beeps will be heard in the head-
set every 10 seconds to indicate that mute is activated.

4.3 Automatic Volume Adjust

The volume of incoming calls is regulated by the Automatic Volume Adjust function,
which is built into the amplifi er. Automatic Volume Adjust automatically adjusts each
incoming call's volume to the same level as that of the previous call, giving you a con-
sistent volume for each and every call you receive.
At any time, you may change the volume of incoming calls by adjusting the manual
headset volume control (G). The volume of your next incoming call will then be at this
new level.
10
1558-979_RevA_20-06-2004_10sprog.indd 10-11 1558-979_RevA_20-06-2004_10sprog.indd 10-11

4.4 Visual indicators

The amplifi er has two visual indicators: the on-line indicator (A)
on the headset stand and the mute indicator (F).
On-line indicator
The on-line indicator (A) fl ashes when speech is detected, indi-
cating to others that you are on a call.
When the amplifi er is fi rst connected to power through the power
adapter, the on-line indicator (A) fl ashes rapidly for 2 seconds.
Mute indicator
A fl ashing mute indicator (F) indicates that you have muted the
call, and that the other party is not able to hear you.
When the amplifi er is fi rst connected to power through the
power adapter, the mute indicator fl ashes rapidly for 2 sec-
onds.
Functions On-line indicator
Power-up, system check Short fl ashes for 2 seconds Short fl ashes for 2 seconds
On-line Flashes when speaking
Muted
Mute indicator
Flashes when muted
11
21-06-2004 11:29:13 21-06-2004 11:29:13