Tabla de contenido
Publicidad
installation guide
STEP 6
Uncoil the Power Cord and connect to the Power Supply.
Place Power Supply on the ground and extend from
the base.
Ensure that the Power
Supply and all attached
cords are directed
toward the desired
surge protector.
To setup Sleeptracker® sensors, see page 16.
STEP 7
Carefully flip the base over on to its legs.
Important: Two people are required to move the bed
base. Do not drag across the floor. Do not rest frame
on its side, excessive pressure may damage the legs.
STEP 8
Plug the base into a power source. A surge protector is
strongly recommended.
WARNING
Always unplug the base from the electrical outlet before servicing any
part of the base. To reduce risk of electric shock, unplug the base before
cleaning. To safely disconnect, ensure the base is in a flat position with all
motors off, and unplug from power source.
Always use two people when setting up the base
STEP 9
Ensure batteries are correctly installed in the back of
the remote.
Quickly test functions to verify proper setup before
placing mattress on base. Press FLAT to return the
base to a flat position.
STEP 10
Place the mattress on the
base.
Select Beautyrest® mattresses*
are compatible with the
mattress retainer attachment
panel installed on the
SmartMotion™ bases
*If the mattress is not
compatible with the
attachment panel, a
mattress retainer bar is
available for purchase at:
1-888-550-3746
Basic setup is now complete!
7
Publicidad
Tabla de contenido
