Hilti DX 35 Manual De Instrucciones página 32

Fault
The cartridge strip doesn't ad-
vance.
The cartridge strip cannot be
removed.
A cartridge doesn't fire.
The cartridge strip melts.
Possible cause
The cartridge strip is damaged.
The tool needs to be cleaned.
The tool is damaged.
The tool has overheated.
Bad cartridge.
The tool needs to be cleaned.
The tool is pressed against the work-
ing surface for too long before firing.
The fastener driving rate is too high.
Remedy
Change the cartridge strip.
Clean the tool.
If the problem persists, contact your
local Hilti Center.
Allow the tool to cool down.
Subsequently, carefully remove the
cartridge strip from the tool.
WARNING
Do not attempt to forcibly remove
cartridges from the magazine strip or
tool.
If the problem persists, contact your
local Hilti Center.
Pull the cartridge strip through to the
next cartridge.
Servicing the tool
WARNING
Check that the correct cartridges are
used and that they are in faultless
condition.
See section: 9.3 Servicing the tool
If the tool cannot be disassembled,
contact your local Hilti Center.
Fire the tool sooner after pressing it
against the working surface.
Remove the cartridge strip.
Stop using the tool immediately.
Remove the cartridge strip and allow
the tool to cool.
WARNING
Do not attempt to forcibly remove
cartridges from the magazine strip or
tool.
Clean the tool and remove any loose
cartridges.
If the tool cannot be disassembled
contact your local Hilti Center.
en
27