HJM 641 Instrucciones De Uso página 26

OPERATION INSTRUCTIONS
1. Before inserting the plug into an electrical outlet, make sure that the
electrical supply in your area matches that on the rating label on the
unit.
2. Carefully remove the heater from the plastic bag and the carton.
3. Place the heater on the wall , setting the master button to "-"position.
Plug the cord set into a AC220-240V~ electrical outlet,with "BEE"
sounds the "Power" light is on and the heater will shows the default
temperature,it
1.HEATING PERPARE
Set Time
Before turn on the heater, set the time as right time. Press remote control
"BLOQ" button, light on control panel, it shows current Room
temperature. WEEK Press "Set" button one time, "I/W" lights on, press
"+ , - "
(1=Monday,2=Tuesday...7=Sunday etc.)
HOUR Press "Set" button again, "II/H" lights on, "+ , 1" two buttons set
the Hours from 01--00(01=1 o'clock,02=2 o'clock...00=24 o'clock etc.)
MINUTE Press "Set" button again, "VENT./MIN." lights on, "+ , - " two
buttons set the Minutes from 00--59(01=1 Minute,02=2 Minute etc.)
PS: Press "Set" button, screen shows number will twinkle 5 seconds, you
should operate in time ,otherwise appliance will get back to standby.
(Appliance will keep the right time until power off).
2)GENERAL USING OPERATION
1. Turn the heater ON by pressing the ON/OFF main button , the unit
will blow the cold air and "VENT./MIN." light is on.
2. Pressing the "MODO" button, the unit will blow the warm air and both
"I/W""VENT./MIN." lights are on.
3. Pressing the "MODO" button second times, the unit will blow the hot
air and both "I/W""VENT./MIN." lights are on.
4. Pressing the "MODO" button Three times, the unit will blow the cold
air and "VENT./MIN." light is on.
PS: Control panel and remote control are same operate way.
will
two buttons
- 26 -
Página 26
twinkle 3
set the week
seconds.
from 1--7
E
N
G
L
I
S
H