Soundcast VGtx Instrucciones De Funcionamiento página 6

Optical out
from TV
To Optical in
Power button, LED indicators
Adjustable
Mounting Tabs
Audio inputs/outputs, Power Connector
Pairing
Note: The VGtx and your Bluetooth® device should be no more than one meter
apart when pairing (the closer the better until paired).
1. Power on your headphones, speaker or other compatible A2DP Bluetooth®
profile device and engage pairing mode.
2. Confirm VGtx is powered-up by connecting USB power cable to power supply
or by turning on with (1 second) mutl- function/power button press if unit had
been previously turned off.
3. Place the VGtx into pairing mode: press and hold the power button (6) sec-
onds until the VGtx LED indicators go from slow flashing blue to alternating red
and blue.
4. When pairing is complete the VGtx Bluetooth indicator will light a solid blue;
pairing has been established.
6
Image A
Optical out to
Soundbar/Amplifier
Image B
facing up
Adjustable
Mounting Tabs
Facing Down
Note: Leave the VGtx continuously connected to USB power, and powered on to
automatically reconnect when the last paired device is within range. If powered
off or disconnected from USB power, the VGtx should automatically reconnect
with the last paired receiving device when both devices are powered on and
within range.
*VGtx with TV Audio
The VGtx paired with any VG series speaker will utilize AptX Low Latency ensur-
ing no delays or lip syncing issues. Other manufacturers speakers which have
AptX Low Latency will also benefit from the AptX Low Latency.
*TWS mode is not recommended for TV audio as the VGtx must default back to
standard aptX when TWS is in use.
Clearing Memory / Factory Reset
The VGtx only has pairing memory for a single device. In order to pair the VGtx
to a new device, you must re-enter pairing mode by pressing the multi-function/
power button for (6) seconds, this will both CLEAR the previously paired device
and put the VGtx into pairing mode where a new device can be paired following
the "Pairing" instructions discussed above.
To factory reset the VGtx and clear pairing memory, press and hold the
multi-function/power button for (10) seconds
until the both the blue and red LED indictors blink rapidly, then release the
multi-function/power button. This indicates that the VGtx has been successfully
reset and pairing memory cleared.
Note: After a factory reset, the internal Bluetooth® pairing memory will be
deleted. You will need to re-pair any previously paired device in order for the VGtx
to properly connect to it again.